10/30/2022 0 Comments Dos 6.22 images![]() #Dos 6.22 images portableThat’s it! As you can tell, restoring the Compaq Portable 386 is relatively straightforward if you’re even mildly tech-savvy- the components are pretty robust, and due to the price of the computer at the time, they were built to last. ![]() You should now be able to boot your Compaq Portable 386 to its hard disk MS-DOS prompt without needing the dos floppy. If, after MS-DOS installation, you get an error message such as “Operating system not found” or something similar, boot to your dos floppy and type “FDISK/MBR.” After executing FDISK/MBR, restart the computer once more. It seems this step may be necessary even after an MS-DOS installation else, you won’t get a hard disk command prompt. Drag-and-drop all the programs that you want to use in DOS onto the WinImage interface, confirming any dialogues that appear. Select Image >Change Format, and increase the size of the boot disk to 2.88 MB - this will give you the space you'll need to inject your programs into it. Once you have successfully installed MS-DOS, boot again from your dos boot disk, and then type FDISK /MBR at the command prompt – this adds the master boot record to your disk allowing your computer to boot from the CF card / hard disk directly. Open the DOS 6.22 boot floppy disk using WinImage. Follow the commands in FDISK to create your MSDOS partition(s) first (in case you want to set up multiple partitions or adjust their sizes), then restart and resume MS-DOS setup. Exit the setup program (press F3) and type FDISK at the command prompt, and press enter – if all is well, the FDISK program should load and give you a series of choices – press “4” to view the existing disk, partitions, and logical drives. I recommend exiting MS-DOS setup to check that the hard disks / compact flash cards are configured correctly. If you don’t have a setup disk and just used an MS-DOS boot disk, the computer should at least boot to command prompt, showing “A:/>”. #Dos 6.22 images installAfter confirming the hard disks are correctly set up properly, restart the computer and insert an MS-DOS boot disk or MS-DOS install disk – if all went well in previous steps, the computer should boot from this disk, then automatically run MSDOS setup.The cool thing if you use Compaq MS-DOS, you get this amazing retro COMPAQ logo from the ’80s at boot. Once you have your floppy disk, boot into the Compaq Diagnostics program to correctly set up the hard drive. ![]() If you can’t make floppy disks, you can try to find the disks on eBay or leave a comment below, and I will try and help. If you are using a 3.25-inch disk, then you will need to use the 720k version. If you are using a 5 1/2 inch floppy drive, you will need to create the diagnostic disk using the 360K version.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |